Defrost Cycle In Your Lg Refrigerator

LG refrigerators which are that you can buy include only two types of defrost techniques. The 1st design often is the Adaptive defrost board. This is an automated circuit mother board which will regulates the on/off precious time plus frequency in the fridge defrosts time period.

Your second type of is going to be defrost timer. The item will be easy to see what sort you may have just by getting your model no . and then calling a local appliance components company. Within this post we are examining and also changing the specific defrost timer.

Taking off the defrost timer. Usually the defrost timer is frequently within the compressor area at the back of your refrigerator. This may also be found behind the front grille, within the temperature control console, or possibly at the rear of the cover plate inside the refrigerator (inset).

To take out any defrost timer, unplug the refrigerator along with unscrew the timer in your case. Remove the green cable of your timer. This timer is linked in to the electrical circuitry by way of harness connect, in which incorporates 4 contacts. To assist you to reconnect this in the correct position, tag one side of your connect as well as the defrost timer with masking tape ahead of removing away the connect.

Evaluating the defrost timer. Find the common terminal of this timer, commonly linked to the white wire within the harness plug (in case the terminals are numbered, its number 3). Hook up one multitester probe to the common terminal and then, while using meter set on RX100, touch the other probe to every of your other 3 terminals. 2 of these pairs need to have full continuity while the third should have no continuity.

Then simply, by using a screw driver, turn the defrost timer switch yourself up until you hear a click. Test out your timer once again exactly the same way. two of the 3 terminal pairs have to show continuity, while your third -not the same 1 as before- should not. In either check, in the event all of 3 sets have continuity, or maybe just one single does, the actual defrost timer is without a doubt defective. To put in a brand new defrost timer or simply reinstall the existing one, hook up your green ground wire after which hook up your harness connector. Screw the defrost timer on the refrigerator cabinet and in addition replace the back panel, if any.

Should you have a LG Refrigerator that has a computer controlled Adaptive defrost board. Shown below is a very standard means of testing your control board.

Refrigerators coming from LG offer an automated touch pad graphical user interface where the particular functions and features of your refrigerator will be selected and set. Pressing a mixture of these specific control panel buttons puts your refrigerator in test mode. When it is in test mode, certain functions and operations with the refrigerator is going to be activated and viewed intended for diagnostic purposes.

Instructions

1) Hit the “Express Freezing” key and also “Colder” key in the Freezer Temp function at the same time and hold for three seconds. Your refrigerator should enter Test Mode 1. Test Mode 1 will allow diagnostic function of the compressor and freezer fan, stepping damper open, defrosting heater off and display LEDs all on.

2) Push your “Express Freezing” key plus the “Colder” key of the Freezer Temperature function together when it is in Test Mode 1 and maintain for 3 seconds. The refrigerator will enter Test Mode 2. Test Mode 2 allows diagnostic operation of your compressor as well as freezer fan, stepping damper close and defrosting heater off.

3) Press the “Express Freezing” key plus the “Colder” key on the Freezer Temperature function together when it is in Test Mode 2 and maintain for 3 seconds. Your refrigerator should go into Test Mode 3. Test Mode 3 will allow diagnostic operations of the compressor and freezer fan off, stepping damper close and defrosting heater on.

4) Press your “Express Freezing” key plus the “Colder” key of the Freezer Temp function while doing so when it is in Test Mode 3 and hold for 3 seconds. The refrigerator will reset to the state prior to entering test mode.

5) Disconnect your refrigerator from the wall outlet, then simply connect it back in to reset the appliance just after emerging from test mode.

Article Source: sooperarticles.com/home-improvement-articles/diy-articles/defrost-cycle-your-lg-refrigerator-741272.html

About Author:

If your having trouble with your LG Refrigerator and live in the Dallas, Plano or Richardson Tx. area Click here for help. LG Appliance Repair in Dallas Tx. or LG Refrigerator Repair in Richardson Tx. or LG Refrigerator Repair in Plano Tx.Author: Gil Hagemann